PheeNet, Wireless Outdoor Bridge, Wireless Backhaul, Wireless AP, Wireless Coverage Network, Total Solution Provider
Wireless Outdoor Bridge, Wireless Backhaul, Wireless AP, Wireless Mesh network, Wireless Coverage network, Wireless Surveillance, Wireless Hotspot Gateway, Taiwan, China, Manufacturers WLO-12400N

IEEE802.11n 2.4GHz 2T2R 300Mbps MIMO Wireless Outdoor Bridge / Wireless Backhaul, (800mW, 2 x N-Type connector, 2 x Ethernet)

PheeNet WLO-12400N is an IEEE802.11bgn 2.4GHz 2T2R 300Mbps MIMO Wireless Outdoor Bridge / AP, which has 2 N-type connectors for external antenna and 2 LAN Ports (1 for LAN POE In, and another for LAN POE Pass-Through to another POE device). With WLO-12400N’s LAN POE Pass-Through port, 1 POE source can power on both WLO-12400N and another POE device, like POE IP Camera or POE AP, etc. 

WLO-12400N supports rich operation modes, like Router AP, WDS, AP, CPE + Universal Repeater, and Client Bridge + Universal Repeater. You can use WLO-12400N as a standalone AP to service 2.4GHz Wifi users; WDS mode to build up Point-to-Point or Point-to-Multiple-Point Bridge; Router AP mode to use WLO-12400N as a Router and Wifi AP. Because of rich operation mode support, it provides the installer more flexible deployments depends on demands. 

If you use WLO-12400N as a Wireless Hotspot Outdoor AP, you also can add PheeNet Network Access Control Gateway WMS-308N to have WLO-12400N AP management, and smart Wifi user management. 

Equips with robust Die Cast Housing and IP68 rated waterproof, WLO-12400N extremely satisfy WISP, Telecom Operator, System Integrator, Hotspot, SMB/Enterprise demands on any kind of Outdoor Wireless applications.

Technique scope:
Wimax, Wifi ,Wireless mesh network, wireless coverage network, wireless backhaul, mobile live video, Wireless Mobility, Wireless Surveillance, Wireless Video, outdoor ap, long range, high capacity, licensed band, NOLS technology, IEEE802.11abgn, outdoor wireless antenna, licensed band antenna, Wireless Outdoor Bridge, Outdoor Bridge, Wireless Bridge, Digital microwave radio, Long Range Wireless Outdoor AP/ Bridge/ CPE, Outdoor Wireless Access Point, Point-to-Point (PtP) / Point-to-Multipoint (PtMP) bridging, Wireless broadband, IP68 weatherproof case

General Features
■ IEEE 802.11n draft 2.0 compliance in 2Tx/2Rx design
■ Support IEEE 802.11b, g, n
■ Operates in the 2.4GHz ISM band
■ Enables bandwidth of up to 300Mbps(Tx) , 300Mbps (Rx) link rate
■ Over load current protection
■ Wide Range Voltage support (12-68VDC)
■ Integrated Power over Ethernet (PoE)

Wireless Features
■ Number of ESSID (Virtual AP) : 7
■ Number of associated clients per AP : 32
■ Setting for max number associated clients
■ Number of Max. WDS Setting : 4
■ Setting for transmission speed, Dynamic Wireless Re-transmission
■ Channel Selection: Manual or Auto
■ Transmission Power Control : 1~100%
■ IEEE802.11h – TPC and DFS
■ IEEE802.11d – Multi country roaming
■ Channel Bandwidth Setting : 20MHz or 20/40MHz
■ Wireless Site Survey
■ IEEE802.11f IAPP : to facilitable faster roaming for the stations among different
APs nearby
■ IEEE 802.11i Preauth (PMKSA Cache )
■ HT Tx/Rx Stream selection : 1 or 2
■ A-MSDU and A-MPDU support
■ Maximal MPDU density for TX aggregation setting
■ Short Slot support
■ RTS Threshold and Fragment Threshold support

■ Support Static IP, Dynamic IP(DHCP Client) and PPPoE on WAN Connection
■ Support VPN Pass Through ( PPTP , IPSec , L2TP )
■ PPPoE Reconnect : Always on, On demand, Manual
■ MAC Cloning
■ DHCP Server (for CPE mode and Client Bridge mode)
■ 802.3 Bridging
■ Masquerading (NAT) (for CPE Mode)
■ Proxy DNS
■ Dynamic DNS
■ NTP Client
■ Virtual DMZ
■ Virtual Server (Port Forwarding)
■ Support MAC Filter
■ Support IP Filter
■ Bandwidth traffic Shaping

Wireless Security
■ Layer 2 User Isolation
■ Layer 2 AP Isolation
■ Blocks client to client discovery within a specified VLAN
■ WEP 64/ 128 Bits
■ EAP-TLS + Dynamic WEP
■ EAP-TTLS + Dynamic WEP
■ PEAP/ MS-PEAP + Dynamic WEP
■ WPA (802.1x certification + TKIP)
■ 802.11i WPA2 (PSK + CCMP/ AES)
■ 802.11i WPA2 (802.1x certification + CCMP/ AES)
■ Setting for TKIP/ CCMP/ AES key’s refreshing period
■ Hidden ESSID support
■ Setting for “ Deny ANY “ connection request
■ MAC Address filtering (MAC ACL)
■ No. of registered RADIUS servers : 1
■ VLAN assignment on BSSID
■ Support WEP, AES and TKIP data encryption over WDS link

Quality of Service
■ Download and Upload traffic control
■ Packet classifications via DSCP (Differentiated Services Code Point)
■ Control Policy by IP/IP Ranges/ MAC/ Service
■ Layer-7 Protocol Support
■ Traffic Analysis and Statistics
■ No. of Max. Policy setting : 10
■ DiffServ/ TOS
■ IEEE802.11p/ COS
■ IEEE 802.11Q Tag VLAN priority control
■ IEEE802.11e WMM

■ Web-Based management & firmware upgrade
■ Reset to factory default
■ Profile Configuration Backup and Restore
■ Remote Link Test – Display connect statistics
■ Full Statistics and Status Reporting
■ NTP Time Synchronization
■ Event Log
■ Support SNMP v1, v2c, v3, MIBII
■ SNMP Traps to a list of IP address
■ CLI access via Telnet and SSH
■ Administrative Access: HTTP and HTTPS
■ UPnP (Universal Plug and Play)
■ Can be managed by WMS-308N, WSW-1808A



IEEE 802.11b/g/n
IEEE 802.3u 100Base-TX Fast Ethernet

 Frequency Band

2.412 ~ 2.462GHz (USA)
2.412 ~ 2.484GHz (Japan) 
2.412 ~ 2.472 GHz (Europe ETSI)
2.457 ~ 2.462 GHz (Spain)
2.457 ~ 2.472 GHz (France)

 Channel Spacing

IEEE802.11b/g: 20MHz
IEEE802.11n: 20/40MHz


IEEE802.11g/n: OFDM (64QAM, 16QAM, QPSK, BPSK)

 Data Rate

IEEE802.11b: 1/2/5.5/11Mbps(auto sensing)


WEP (64/128Bit)
Hidden ESSID User Isolation
AP Isolation
MAC Address Filter

 Receive Sensitivity


 Output Power


 Operating Mode

AP mode (AP +WDS)
WDS Mode (PTP, PTMP, Repeater)
CPE Mode (Router Client )
Universal Repeater + Client Bridge



Atheros AR9341 – 400MHz MIPS CPU





 LED Indication

Power/LAN, Power/WAN ,Wireless


- 10/100BASE-TX auto-negotiation
Ethernet port x 2 (RJ-45 connector)
- Power over Ethernet


2 x Ntype Connector


Operating Temperature: -20 °C ~ 60 °C
Storage Temperature: -20 °C ~ 85 °C Humidity: 100%(non condensing)

 Power Supply

DC Input : 12V
POE : 48 VDC, 0.4A input (POE Injector)

 Power Consumption



Aluminum Alloy Housing, W/ IP68 Rated Waterproof


157 (L) x 96 (W) x 45 (H) mm