|
|
|
>>
Product
>
>
> WLO-15802N
|
| |
|
|
| |
 |
WLO-15802N |
|
|
IEEE802.11a/n 5GHz 300Mbps MIMO Wifi / Wireless Outdoor Bridge / Wireless Backhaul, W/2 x N-Type connector) |
| |
|
|
| |
PheeNet WLO-15802N positioned as a Wifi / Wifi / Wireless Backhaul to provide up to 10KM distance and 90Mbps throughput. It operates at 5GHz Frequency band, and comply with IEEE802.11n 300Mbps data rate.
Not only can act as the Wireless Backhaul, WLO-15802N equips with CPE and AP mode, which requested by WISP most of time. By integrating Bandwidth management, QOS features, WISP can easily control the upstream and downstream bandwidth by the cost end users pay.
Equips with robust Die Cast housing and IP68 rated waterproof, WLO-15802N extremely satisfy WISP, Telecom Operator, SMB / Enterprise's demands on any kind of tough Outdoor Wireless application.
Technique scope:
Wimax, Wifi ,Wireless mesh network,wireless coverage network,wireless backhaul, mobile live video, Wireless Mobility, Wireless Surveillance, Wireless Video, outdoor ap, long range, high capacity, licensed band, NOLS technology, IEEE 802.11 abgn, outdoor wireless antenna, licensed band antenna, Wireless Outdoor Bridge, Outdoor Bridge, Wireless Bridge, Digital microwave radio, Long Range Wireless Outdoor AP/ Bridge/ CPE, Outdoor Wireless Access Point, Point-to-Point (PtP) / Point-to-Multipoint (PtMP) bridging, Wireless broadband, IP68 weatherproof casing, MMDS, PDH, SDH, STM1, STM-1
|
|
| |
|
|
| |
 |
|
| |
 |
|
| |
|
|
|
| |
 |
|
| |
General Features
■ IEEE 802.11n draft 2.0 compliance in 2Tx/2Rx design
■ Support IEEE 802.11n and 802.11a
■ Operates in the 5GHz ISM band
■ Enables bandwidth of up to 300Mbps(Tx) , 300Mbps (Rx) link rate
■ Over load current protection
■ Wide Range Voltage support (12-68VDC)
■ Integragted Power over Ethernet (PoE)
■ IP68 Rated Weather-Proof Housing, M-13 RJ45 and N-Type Connector
Wireless Features
■ Number of ESSID (Virtual AP) : 7
■ Number of associated clients per AP : 32
■ Setting for max number associated clients
■ Number of Max. WDS Setting : 4
■ Setting for 802.11a/n mix or 802.11a only
■ Setting for transmission speed, Dynamic Wireless Re-transmission
■ Channel Selection: Manual or Auto
■ Transmission Power Control : 1~100%
■ IEEE802.11h - PTC and DFS
■ IEEE802.11d - Multi country roaming
■ Channel Bandwidth Seeting : 20MHz or 20/40MHz
■ Wireless Site Survey
■ Operation Modes : AP Mode (AP / AP+WDS) , WDS Mode (Bridge / Repeater) , CPE Mode (Router / client), Universal Repeater + Client Bridge Mode
■ IEEE802.11f IAPP : to facilitable faster roaming for the stations among different
APs nearby
■ IEEE 802.11i Preauth (PMKSA Cache )
■ HT Tx/Rx Stream selection : 1 or 2
■ A-MSDU and A-MPDU support
■ Maximal MPDU density for TX aggregation setting
■ Short Slot support
■ RTS Threshold and Fragment Threshold support
Networking
■ Support Static IP, Dynamic IP(DHCP Client) and PPPoE on WAN Connection
■ Support VPN Pass Throughput ( PPTP , IPSec , L2TP )
■ PPPoE Reconnect : Always on , On demand, Manual
■ MAC Cloning
■ DHCP Server
■ 802.3 Bridging
■ DHCP Server ( for CPE Mode and Client Bridge Made )
■Masquerading (NAT) (for CPE Mode)
■ Proxy DNS
■ Dynamic DNS
■ NTP Client
■ Virtual DMZ
■ Virtual Server (Port Forwarding)
■ Support MAC Filter
■ Support IP Filter
■ Bandwidth traffic Shaping
Wireless Security
■ Layer 2 User Isolation
■ Layer 2 AP Isolation
■ Blocks client to client discovery within a specified VLAN
■ WEP 64/ 128 Bits
■ EAP-TLS + Dynamic WEP
■ EAP-TTLS + Dynamic WEP
■ PEAP/ MS-PEAP + Dynamic WEP
■ WPA (PSK +TKIP)
■ WPA (802.1x certification + TKIP)
■ 802.11i WPA2 (PSK + CCMP/ AES)
■ 802.11i WPA2 (802.1x certification + CCMP/ AES)
■ Setting for TKIP/ CCMP/ AES key's refreshing period
■ Hidden ESSID support
■ Setting for "Deny ANY" connection request
■ MAC Address filtering (MAC ACL)
■ No. of registered RADIUS servers : 1
■ VLAN assignment on BSSID
Quality of Service
■ Download and Upload traffic control
■ Packet classifications via DSCP (Differentiated Services Code Point)
■ Control Policy by IP/IP Ranges/ MAC/ Service
■ Layer-7 Protocol Support
■ Traffic Analysis and Statistics
■ No. of Max. Policy setting : 10
■ DiffServ/ TOS
■ IEEE802.11p/ COS
■ IEEE 802.11Q Tag VLAN priority control
■ IEEE802.11e WMM
Management
■ Web-Based management & firmware upgrade
■ Reset to factory default
■ Profile Configuration Backup and Restore
■ Remote Link Test �V Display connect statistics
■ Full Statistics and Status Reporting
■ NTP Time Synchronization
■ Event Log
■ Support SNMP v1, v2c, v3, MIBII
■ SNMP Traps to a list of IP address
■ CLI access via Telnet and SSH
■ Administrative Access: HTTP and HTTPS
■ UPnP (Universal Plug and Play)
|
|
|
|
|
|
| |
 |
|
| |
Wireless |
|
| |
Standard |
IEEE 802.11n
IEEE 802.11a
IEEE 802.3u 100Base-TX Fast Ethernet
IEEE802.11f
IEEE802.11i
IEEE802.11d
|
|
| |
Frequency Band |
IEEE802.11a:
5.15~5.35 & 5.725~ 5.825 GHz for US
4.9~5.25 GHz for Japan
5.15~5.35 & 5.47~5.725 GHz for ETSI
IEEE802.11n :
5.15~5.35 & 5.725~ 5.825 GHz for US
4.9~5.25 GHz for Japan
5.15~5.35 & 5.47~5.725 GHz for ETSI
|
|
| |
Channel Spacing |
IEEE802.11a: 20MHz
IEEE802.11n: 20/40MHz
|
|
| |
Operating Channels |
IEEE802.11a / IEEE802.11n:
US: 12 (Ch:36,40,44,48,52,56,60,64,149,153,157, 161)
Japan: 4 (Ch:34,38,42,46) ETSI:19(Ch:36,40,44,48,52,56,60,64,100,104,108, 112,116,120,124,128,132,136,140)
|
|
| |
Modulation |
IEEE802.11a: OFDM (64QAM, QAM, QPSK, BPSK)
IEEE802.11n: BPSK, QPSK, 16QAM, 64QAM
|
|
| |
Data Rate |
IEEE802.11a: 6/9/12/18/24/36/48/54Mbps (auto sensing)
IEEE802.11n(draft 2.0) : 300Mbps(Tx), 300Mbps(Rx)
|
|
| |
Security |
WEP (64/128Bit)
WPA / WPA2
Hidden ESSID
User Isolation
MAC Address Filter
|
|
| |
Receive Sensitivity |
-97dBm |
|
| |
Output Power |
27dBm (500mW) |
|
| |
Operating Mode |
Pure AP
AP / WDS
Pure WDS Mode (Repeater/Bridge)
CPE Mode (Router Client )
Universal Repeater
|
|
| |
Hardware |
|
| |
Processor |
Ralink 2880 + 2850 (5G RF) |
|
| |
Flash |
4MB |
|
| |
SDRAM |
32MB |
|
| |
LED Indication |
Power, LAN ,Wireless |
|
| |
Antenna Connector |
2 x N-Type |
|
| |
Ethernet |
- 10/100BASE-TX auto-negotiation Ethernet port x 1 (RJ-45 connector)
- Power over Ethernet
|
|
| |
Environment |
Operating Temperature: -30℃ ~ 60℃
Storage Temperature: -30℃ ~ 85℃
Humidity: 100%(non condensing)
|
|
| |
Power Supply |
AC Input : 110 - 220V AC Power
DC Output : 48 VDC, 0.4A input (POE Injector)
|
|
| |
Power Consumption |
9W |
|
| |
Waterproof |
IP68 Certificated, Die-Cast aluminum Enclosure |
|
| |
Mounting |
Wall Mount, Pole Mount |
|
| |
Dimensions |
157 (L) x 96 (W) x 45 (H) mm |
|
| |
Weight |
0.68Kg |
|
| |
Certificate |
CE, FCC |
|
| |
|
TOP |
|
| |
|
|
|
| |
|
 |
|
| |
|
|
|
|
